Analytical solution of conductor tensile force in asymmetrical spans used in overhead power lines and substations with influence of tension insulators
DOI:
https://doi.org/10.20998/2074-272X.2024.5.09Keywords:
substation, asymmetrical span, tension section, state changeAbstract
Introduction. Designing electrical substations involves analyzing the horizontal tensile force in flexible tension conductors under varying temperatures. These temperature changes affect the conductor’s length and forces. Problem. Existing methods for calculating horizontal tensile force in conductors often focus on symmetric spans or require complex finite element modeling (FEM), which is impractical for routine substation design. Asymmetric spans with tension insulators present a more complex challenge that current solutions do not adequately address. Purpose. Universal analytical solution and algorithm for calculating the horizontal tensile forces in conductors in asymmetric spans with tension insulators used in power substations or short overhead power line spans. The solution is designed to be easily implementable in software without requiring complex tools or extensive FEM. Methodology. The methodology involves deriving an analytical solution based on the catenary curve formed by the conductor between attachment points at different heights. The analysis includes calculating the conductor’s length for a given tensile force and using a state change equation to determine forces under new temperature conditions. Validation is performed using FEM calculations. Results. The proposed solution was validated against FEM models with varying height differences (5 m and 15 m) and conductor temperatures (–30 °C, –5 °C, +80 °C). The results showed a minimal error (less than 0.15 %) between the analytical solution and FEM results, demonstrating high accuracy. Originality. This paper presents a novel analytical solution to the problem of calculating tensile forces in asymmetric spans with tension insulators. Unlike existing methods, our solution is straightforward and easily implementable in any programming language. Practical value. The solution is practical for routine design tasks in electrical substations or short overhead power lines. Especially in power substations, accurate tensile forces are needed not only for mechanical design and sag calculations but also for calculating the dynamic effects of short-circuit currents. References 23, tables 4, figures 3.
References
Al-Qarni A.S., Ramdas S.K. Voltage Sag Assessment and Mitigation Techniques of a Solar PV Integrated 110 kV/13.8 kV Saudi Substation. European Journal of Engineering and Technology Research, 2022, vol. 7, no. 6, pp. 56-63. doi: https://doi.org/10.24018/ejeng.2022.7.6.2902.
Santos G.R., Zancul E. A framework to assess the impacts of digital electrical substations. Smart Energy, 2023, vol. 12, art. no. 100125. doi: https://doi.org/10.1016/j.segy.2023.100125.
Rácz L., Németh B., Göcsei G., Zarchev D., Mladenov V. Performance Analysis of a Dynamic Line Rating System Based on Project Experiences. Energies, 2022, vol. 15, no. 3, art. no. 1003. doi: https://doi.org/10.3390/en15031003.
Gaspar J., Cruz T., Lam C.-T., Simões P. Smart Substation Communications and Cybersecurity: A Comprehensive Survey. IEEE Communications Surveys & Tutorials, 2023, vol. 25, no. 4, pp. 2456-2493. doi: https://doi.org/10.1109/COMST.2023.3305468.
CIGRE-B2.12.3. 324-Sag-Tension Calculation Methods for Overhead Lines. 2016. 91 p.
Pavon W., Inga E., Simani S., Nonato M. A Review on Optimal Control for the Smart Grid Electrical Substation Enhancing Transition Stability. Energies, 2021, vol. 14, no. 24, art. no. 8451. doi: https://doi.org/10.3390/en14248451.
Krasnozhon A.V., Kvytsynskyi A.O., Buinyi R.O., Dihtyaruk I.V., Krasnozhon O.V. Study of the influence of the parameters of modern grounding wires on the value of power losses in them for overhead power lines of 330-750 kV. Electrical Engineering & Electromechanics, 2023, no. 6, pp. 77-83. doi: https://doi.org/10.20998/2074-272X.2023.6.14.
Kiessling F., Nefzger P., Nolasco J.F., Kaintzyk U. Overhead Power Lines: Planning, Design, Construction. Springer Science & Business Media, 2003. 759 p.
Bendik J., Cenky M., Eleschova Z., Belan A., Cintula B., Janiga P. Influence of Tension Insulators and Bundle Conductors on Sag of Conductors in Substations. 2022 22nd International Scientific Conference on Electric Power Engineering (EPE), 2022, pp. 1-5. doi: https://doi.org/10.1109/EPE54603.2022.9814112.
Wang X., Hong Z., Min Q., Zou D., Zhao X., Xie Q. Seismic performance analysis of double electrical equipment system connected by flexible conductors. E3S Web of Conferences, 2024, vol. 522, art. no. 01024. doi: https://doi.org/10.1051/e3sconf/202452201024.
Redmond J. Revit 3D Modeling Optimizes Substation Design. 2022 IEEE Rural Electric Power Conference (REPC), 2022, pp. 84-87. doi: https://doi.org/10.1109/REPEC55671.2022.00023.
Musgrave D., Bellaschi P., Berry L., Brader D., Byron R., Crouch G., Dolan P., Fiero D., Finley G., Hertig G., Maneatis J., Shoun P., Supplee G., Taylor E., Zanzie C. Minimum Line-To-Ground Electrical Clearances for EHV Substations Based on Switching Surge Requirements. IEEE Transactions on Power Apparatus and Systems, 1972, vol. PAS-91, no. 5, pp. 1924-1930. doi: https://doi.org/10.1109/TPAS.1972.293520.
International Standard IEC 60865-1:2011 - Short-circuit currents - Calculation of effects - Part 1: Definitions and calculation methods. Oct. 24, 2011. 102 p.
Stenzel D., Librandi M.D., Witzmann R., Schmidt J.M., Milic V. Substation Topology Planning: Impact on Voltage Stability and Short-circuit Current. 2023 IEEE Belgrade PowerTech, 2023, pp. 01-06. doi: https://doi.org/10.1109/PowerTech55446.2023.10202737.
Piechocki P., Frackowiak R., Dombek G., Chmielewska I. Estimation of Short Circuit Duration for the Assessment of Dynamic Effects in Distribution Substations with Flexible Conductors. Energies, 2020, vol. 13, no. 4, art. no. 970. doi: https://doi.org/10.3390/en13040970.
Verma A., Swarup K.S. Dynamic line rating considering short term reliability and convergence time. Energy Systems, 2023. Article in Press. doi: https://doi.org/10.1007/s12667-023-00592-1.
Reich K., Weissnar R., Puffer R. Investigation of the dynamic rating of tubular busbars in substations. Elektrotechnik Und Informationstechnik, 2020, vol. 137, no. 8, pp. 455-459. doi: https://doi.org/10.1007/s00502-020-00847-0.
Koliushko D.G., Rudenko S.S., Tyutyuma S.O., Vorobiov B.V. Determination of the electric field strength of high-voltage substations. Electrical Engineering & Electromechanics, 2023, no. 5, pp. 63-68. doi: https://doi.org/10.20998/2074-272X.2023.5.09.
Boumous S., Boumous Z., Anane Z., Nouri H. Comparative study of 220 kV overhead transmission lines models subjected to lightning strike simulation by using electromagnetic and alternative transients program. Electrical Engineering & Electromechanics, 2022, no. 4, pp. 68-74. doi: https://doi.org/10.20998/2074-272X.2022.4.10.
Kuznetsov B.I., Nikitina T.B., Bovdui I.V., Voloshko O.V., Kolomiets V.V., Kobylianskyi B.B. The method of multi-objective parametric design of magnetic field active canceling robust system for residential multy-story buildings closed to double-circuit overhead power lines. Electrical Engineering & Electromechanics, 2023, no. 2, pp. 27-36. doi: https://doi.org/10.20998/2074-272X.2023.2.05.
Zhang R., Zhao X., Shen G., Yao J. Finite element simulation of wire’s sag considering tension insulator string. Energy Reports, 2022, vol. 8, pp. 101-108. doi: https://doi.org/10.1016/j.egyr.2021.11.018.
Zhang R., Li J., Zhao X., Yao C. Study on the sag of ultra high voltage conductor with large-tonnage tension insulator string. Energy Reports, 2022, vol. 8, pp. 394-404. doi: https://doi.org/10.1016/j.egyr.2022.05.091.
Quintana J., Garza V., Zamudio C. Sag-tension calculation program for power substations. 2016 IEEE PES Transmission & Distribution Conference and Exposition-Latin America (PES T&D-LA), 2016, pp. 1-4. doi: https://doi.org/10.1109/TDC-LA.2016.7805629.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2024 J. Bendik, M. Cenky, J. Paulech, V. Goga
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
Authors who publish with this journal agree to the following terms:
1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.