Experimental electromagnetic compatibility of conducted electromagnetic interferences from an IGBT and a MOSFET in the power supply
DOI:
https://doi.org/10.20998/2074-272X.2024.3.05Keywords:
electromagnetic interference, electromagnetic compatibility, common-mode, differential-mode, IGBT, MOSFETAbstract
Introduction. Most electromagnetic compatibility studies carried out in the context of power switch research are generally valid for low frequencies. This frequency restriction appears to be too restrictive for a complete analysis of the electromagnetic interference conducted. The novelty of this work lies in the load-dependent an optimal selection of IGBTs and MOSFETs for least-disturbance power switching in the frequency range from 150 kHz to 30 MHz, based on an optimal experimental selection procedure and show the impact of load value on switch switching and noise generation. Purpose. Analysis of the fundamental possibility of selecting a switching device with a power supply based on an experimental measurement which allows to increase the reliability of the entire mechanism operation and significantly simplify the design. Methods. In this paper, the proposed study is used and compared with experimental results at low and high frequencies. Then, a comparison is made for conducted electromagnetic interference (common-mode and differential-mode) generated by IGBT and MOSFET for different loads, and the proposed methodology is verified on an experiment suitable for predicting terminal overvoltage analysis and conducted electromagnetic interference problems. Practical value. The primary method for establishing a conducted electromagnetic interference source for switching devices is based on IGBT and a MOSFET depending on the resistive load. References 22, figures 17.
References
Miloudi M., Bendaoud A., Miloudi H. Common and differential modes of conducted electromagnetic interference in switching power converters. Revue Roumaine Des Sciences Techniques Serie Electrotechnique et Energetique, 2017, vol. 62, no. 3, pp. 246-251.
Miloudi H., Bendaoud A., Miloudi M. A method for modeling a common-mode impedance for the AC motor. Elektrotehniski Vestnik/Electrotechnical Review, 2017, vol. 84, no. 5, pp. 241-246.
Miloudi H., Miloudi M., Gourbi A., Bermaki M.H., Bendaoud A., Zeghoudi A. A high-frequency modeling of AC motor in a frequency range from 40 Hz to 110 MHz. Electrical Engineering & Electromechanics, 2022, no. 6, pp. 3-7. doi: https://doi.org/10.20998/2074-272X.2022.6.01.
Wunsch B., Skibin S., Forsström V., Stevanovic I. EMC Component Modeling and System-Level Simulations of Power Converters: AC Motor Drives. Energies, 2021, vol. 14, no. 6, art. no. 1568. doi: https://doi.org/10.3390/en14061568.
Miloudi M., Miloudi H., Bendaoud A., Salhi M.A., Al-Omari A.N. Experimental characterization of the high-frequency isolating power transformer. Elektrotehniski Vestnik/Electrotechnical Review, 2019, vol. 86, no. 4, pp. 211-218.
Benazza B., Bendaoud A., Slimani H., Benaissa M., Flitti M., Zeghoudi A. Experimental study of electromagnetic disturbances in common and differential modes in a circuit based on two DC/DC boost static converter in parallel. Electrical Engineering & Electromechanics, 2023, no. 4, pp. 35-39. doi: https://doi.org/10.20998/2074-272X.2023.4.05.
Li Y., Dang Y., Zhang S., Li X., Jin Y., Ben-Abdallah P., Xu J., Ma Y. Radiative Thermal Transistor. Physical Review Applied, 2023, vol. 20, no. 2, art. no. 024061. doi: https://doi.org/10.1103/PhysRevApplied.20.024061.
Chikhi N., Bendaoud A. Evaluation of Conducted Disturbances Generated by the Chopper-rectifier Association Propagating to the Electrical Network. European Journal of Electrical Engineering, 2019, vol. 21, no. 1, pp. 1-6. doi: https://doi.org/10.18280/ejee.210101.
Muller D., Schweitzer D.N., Beltle M., Tenbohlen S. An Active Common Mode EMI Filter Approach introducing Predictive Pulsed Compensation. 2019 International Symposium on Electromagnetic Compatibility - EMC EUROPE, 2019, pp. 1003-1008. doi: https://doi.org/10.1109/EMCEurope.2019.8872104.
Kharanaq F.A., Emadi A., Bilgin B. Modeling of Conducted Emissions for EMI Analysis of Power Converters: State-of-the-Art Review. IEEE Access, 2020, vol. 8, pp. 189313-189325. doi: https://doi.org/10.1109/ACCESS.2020.3031693.
Xu S.-Z., Peng Y.-F., Li S.-Y. Suppression effectiveness research on multi-level EMI filter in thermal electromagnetic interactive filed of explosion-proof three-level NPC converter. Case Studies in Thermal Engineering, 2019, vol. 15, art. no. 100510. doi: https://doi.org/10.1016/j.csite.2019.100510.
Zeghoudi A., Bendaoud A., Slimani H., Miloudi H., Miloudi M., Chikhi N. Experimental Measurement of Common and Differential Modes for Variable Speed Drive DC Motor. 2022 19th International Multi-Conference on Systems, Signals & Devices (SSD), 2022, pp. 532-537. doi: https://doi.org/10.1109/SSD54932.2022.9955933.
Mariscotti A., Sandrolini L. Review of models and measurement methods for compliance of electromagnetic emissions of electric machines and drives. ACTA IMEKO, 2021, vol. 10, no. 2, pp. 162-173. doi: https://doi.org/10.21014/acta_imeko.v10i2.1066.
Touré M.T., Paladian F., Bensetti M., Robert F., Dufour L. Conducted EMI prediction using different levels of MOSFET models in a multi-physics optimization context. European Journal of Electrical Engineering, 2016, vol. 18, no. 5-6, pp. 425-439. doi: https://doi.org/10.3166/ejee.18.425-439.
Miloudi H., Bendaoud A., Miloudi M., Gourbi A., Slimani H. Common Mode conducted electromagnetic interference in inverter fed-AC motor. Przeglad Elektrotechniczny, 2010, vol. 86, no. 12, pp. 272-275.
Hamoudi A. Modélisation et Caractérisation cem D’un Convertisseur DC-AC. Master’s Thesis. Oran University of Science and Technology, 2009. 169 p. (Fra).
Douzi Chawki. Effet du vieillissement par fatigue électrothermique sur la compatibilité électromagnétique des composants de puissance à base de SiC. Doctor’s Thesis. Normandie Université; Université de Sousse (Tunisie), 2019. 193 p. (Fra).
Yuwono T., Baharuddin M.H., Misran N., Ismail M., Mansor M.F. A review of measurement of electromagnetic emission in electronic product: Techniques and challenges. Communications in Science and Technology, 2022, vol. 7, no. 1, pp. 23-37. doi: https://doi.org/10.21924/cst.7.1.2022.727.
Mariscotti A., Sandrolini L., Simonazzi M. Supraharmonic Emissions from DC Grid Connected Wireless Power Transfer Converters. Energies, 2022, vol. 15, no. 14, art. no. 5229. doi: https://doi.org/10.3390/en15145229.
Wu Y., Yin S., Liu Z., Li H., See K.Y. Experimental Investigation on Electromagnetic Interference (EMI) in Motor Drive Using Silicon Carbide (SiC) MOSFET. 2020 International Symposium on Electromagnetic Compatibility - EMC EUROPE, 2020, pp. 1-6. doi: https://doi.org/10.1109/EMCEUROPE48519.2020.9245674.
Khvitia B., Gheonjian A., Kutchadze Z., Jobava R. A SPICE Model for IGBTs and Power MOSFETs Focusing on EMI/EMC in High-Voltage Systems. Electronics, 2021, vol. 10, no. 22, art. no. 2822. doi: https://doi.org/10.3390/electronics10222822.
Zeghoudi A., Bendaoud A., Lucache D.-D., Bechekir S., Slimani H., Miloudi M. Frequency Variation Impact on Conducted Disturbances Generated by a SEPIC Converter. International Journal of Electronics and Electrical Engineering Systems, 2023, vol. 6, no. 1, pp. 27-32.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2024 M. E. Lahlaci, M. Miloudi, H. Miloudi
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
Authors who publish with this journal agree to the following terms:
1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.